Read before use

Please note the following instructions and tips before use.

Before sticking, glass should be cleaned with white spirit, pure petroleum or acetone and allowed to dry. For strongly absorbent surfaces, somewhat more glue is needed. We recommend that you carry out some preliminary tests with STIXXI™ Glue.
Surfaces to be joined must be free of rust, grease and dust. in some cases (e.g. leather), roughen the surface with sandpaper. Remove traces of old glue the better the joint. Allow the glued items to stand for a few minutes.
Different materials dry at different rates. Best results are obtained at room temperature.
after 7-8 hours, any material will be firmly set.

To open the pipette or bottle do not cut the pipette for pierce with a needle.
Do not point the pipette towards the face while doing so.
Cut open the thinnest side of the bottle with scissors.

I M P O R T A N T!
Light and heat are to be avoided at all costs. Keep bottles and pipettes in upright position!
STIXXI™ Glue is only available from authorized dealers, from trade fairs or directly from us. If you have any questions, please consult us. We will be glad to help you at any time.

CYANACRYLATES! DANGER!
– Do not swallow!
– Do not inhalate vapors!
– It will stick skin or eyelids tight within seconds!
– Keep out of the reach of children!
– Clean off hands with soap and water or hand-cleaner.
– Rinse eyes with special eyewash.
– Consult eye specialist!